Difference between revisions of "Six volt"

From Holdenpaedia
Jump to: navigation, search
Line 1: Line 1:
Originally submitted by T.<br />[http://www.oldholden.com/possible/index.php/General_information#Electrical Back to Electrical Index]<br />==Six Volt Systems:==<br />===Overview:===<br />In so many ways the words &quot;6 volt system&quot; is just a term.<br /><br />There is no reason why a 6 volt system of a given year of manufacture can't equal a 12 volt system of a given year in performance. <br /><br />The special difference a 6 volt system presents is that every cable has to carry twice the current as a 12 volt system in order to deliver the same power. <br /><br />===Cable Sizes:===<br />Because the current through each conductor is double there is potential for each cable to <br />suffer double the voltage drop if the cables aren't appropriately rated or replaced if they have oxidised through exposure to excessive heat or been overloaded.<br /><br />===System Voltage:===<br />Any automotive electrical system has a system voltage which is higher than the rated battery voltage. With the engine running and turning fast enough the system voltage of a 6 volt system will be about 7 volts.<br /><br />This 7 volts provides sufficient energy to recharge the battery and ensure the electrical loads of the car will be carried by the generator.<br /><br />A vehicle that shows less than 7 volts at the battery with the engine turning above about 1500 rpm will suffer reduced battery life and slow cranking problems.<br /><br />===Dim Lights, Slow Wipers:===<br />Naturally the same cables mentioned in &quot;Dim Headlights, Slow Wipers&quot; need to be replaced if they have become oxidised or are under-rated.<br /><br />If the charging voltage is not 7 volts, achieving a 7 volt output from the generator will probably require an adjustment of the regulator.<br /><br />===Six to 12 Volt Conversion:===<br />Info posted by Q-ball Nov 18 2006:<br /><br />[[Image:12_Volt_FX.jpg|thumbnail|48-215 (FX) with 12V Alternator. Click to enlargen. Image by Q-ball.]]<br /><br />&quot;...Altered an old Red motor Alt. bracket to bolt to the Genny. mounting points...would you belive the shafts are the same size between the Alt. &amp; Gen.!!..so just used the old &quot;B&quot; section pulley with a washer behind it..DONE!!<br />Next change all globes (dash,tail etc) to 12v, fitted a head light relay &amp; wacked in a couple of QH insert lights...so far have only bought the relay..the rest has been in the shed!<br />The headlight conversion was made a little easier by using the headlight harness's from an FJ that had been converted to (6v)sealed beams...these had the right plugs.<br />Next..fuel gauge..it is likely that the gauge &amp; sender would have handled 12 volts..BUT..a mate at the local hobby store built me a small regulator..12 volts in, 6 out..the size of a .50 cent coin, over a cup of coffee for $10.<br />Could have changed the starter, but left it...winds over REAL well.<br />Q-ball.&quot;<br /><p>===Terms:===</p><p>[http://holdenpaedia.oldholden.com/Terms Terms]<br />[http://www.oldholden.com/possible/index.php/General_information#Electrical Back to Electrical Index]<br />[[Category:Electrical]]</p>
+
<p>Originally submitted by T.<br />[http://holdenpaedia.oldholden.com/index.php/General_information#Electrical Back to Electrical Index]<br />==Six Volt Systems:==<br />===Overview:===In so many ways the words &quot;6 volt system&quot; is just a term.<br />There is no reason why a 6 volt system of a given year of manufacture can't equal a 12 volt system of a given year in performance. <br />The special difference a 6 volt system presents is that every cable has to carry twice the current as a 12 volt system in order to deliver the same power. <br /><br />===Cable Sizes:===Because the current through each conductor is double there is potential for each cable to <br />suffer double the voltage drop if the cables aren't appropriately rated or replaced if they have oxidised through exposure to excessive heat or been overloaded.<br /><br />===System Voltage:===Any automotive electrical system has a system voltage which is higher than the rated battery voltage. With the engine running and turning fast enough the system voltage of a 6 volt system will be about 7 volts.<br />This 7 volts provides sufficient energy to recharge the battery and ensure the electrical loads of the car will be carried by the generator.<br />A vehicle that shows less than 7 volts at the battery with the engine turning above about 1500 rpm will suffer reduced battery life and slow cranking problems.<br /><br />===Dim Lights, Slow Wipers:===Naturally the same cables mentioned in &quot;Dim Headlights, Slow Wipers&quot; need to be replaced if they have become oxidised or are under-rated.<br />If the charging voltage is not 7 volts, achieving a 7 volt output from the generator will probably require an adjustment of the regulator.<br /><br />===Six to 12 Volt Conversion:===<em>Info posted by Q-ball Nov 18 2006:</em>[[Image:12_Volt_FX.jpg|thumbnail|48-215 (FX) with 12V Alternator. Click to enlargen. Image by Q-ball.]]<br />&quot;...Altered an old Red motor Alt. bracket to bolt to the Genny. mounting points...would you belive the shafts are the same size between the Alt. &amp; Gen.!!..so just used the old &quot;B&quot; section pulley with a washer behind it..DONE!!<br />Next change all globes (dash,tail etc) to 12v, fitted a head light relay &amp; wacked in a couple of QH insert lights...so far have only bought the relay..the rest has been in the shed!<br />The headlight conversion was made a little easier by using the headlight harness's from an FJ that had been converted to (6v)sealed beams...these had the right plugs.<br />Next..fuel gauge..it is likely that the gauge &amp; sender would have handled 12 volts..BUT..a mate at the local hobby store built me a small regulator..12 volts in, 6 out..the size of a .50 cent coin, over a cup of coffee for $10.<br />Could have changed the starter, but left it...winds over REAL well.<br />Q-ball.&quot;</p><p>&nbsp;</p><p>===Terms:===[http://holdenpaedia.oldholden.com/Terms Terms]</p><p><br />[http://holdenpaedia.oldholden.com/index.php/General_information#Electrical Back to Electrical Index]<br />[[Category:Electrical]]</p>

Revision as of 10:41, 19 July 2007

Originally submitted by T.
Back to Electrical Index
==Six Volt Systems:==
===Overview:===In so many ways the words "6 volt system" is just a term.
There is no reason why a 6 volt system of a given year of manufacture can't equal a 12 volt system of a given year in performance.
The special difference a 6 volt system presents is that every cable has to carry twice the current as a 12 volt system in order to deliver the same power.

===Cable Sizes:===Because the current through each conductor is double there is potential for each cable to
suffer double the voltage drop if the cables aren't appropriately rated or replaced if they have oxidised through exposure to excessive heat or been overloaded.

===System Voltage:===Any automotive electrical system has a system voltage which is higher than the rated battery voltage. With the engine running and turning fast enough the system voltage of a 6 volt system will be about 7 volts.
This 7 volts provides sufficient energy to recharge the battery and ensure the electrical loads of the car will be carried by the generator.
A vehicle that shows less than 7 volts at the battery with the engine turning above about 1500 rpm will suffer reduced battery life and slow cranking problems.

===Dim Lights, Slow Wipers:===Naturally the same cables mentioned in "Dim Headlights, Slow Wipers" need to be replaced if they have become oxidised or are under-rated.
If the charging voltage is not 7 volts, achieving a 7 volt output from the generator will probably require an adjustment of the regulator.

===Six to 12 Volt Conversion:===Info posted by Q-ball Nov 18 2006:

48-215 (FX) with 12V Alternator. Click to enlargen. Image by Q-ball.

"...Altered an old Red motor Alt. bracket to bolt to the Genny. mounting points...would you belive the shafts are the same size between the Alt. & Gen.!!..so just used the old "B" section pulley with a washer behind it..DONE!!
Next change all globes (dash,tail etc) to 12v, fitted a head light relay & wacked in a couple of QH insert lights...so far have only bought the relay..the rest has been in the shed!
The headlight conversion was made a little easier by using the headlight harness's from an FJ that had been converted to (6v)sealed beams...these had the right plugs.
Next..fuel gauge..it is likely that the gauge & sender would have handled 12 volts..BUT..a mate at the local hobby store built me a small regulator..12 volts in, 6 out..the size of a .50 cent coin, over a cup of coffee for $10.
Could have changed the starter, but left it...winds over REAL well.
Q-ball."

 

===Terms:===Terms


Back to Electrical Index